Active TopicsActive Topics  Display List of Forum MembersMemberlist  CalendarCalendar  Search The ForumSearch  HelpHelp
  RegisterRegister  LoginLogin
Set Design and Construction
 Community Theater Green Room Discussion Board :Producing Theater :Set Design and Construction
Message Icon Topic: finishing touches on interior set(Topic Closed Topic Closed) Post Reply Post New Topic
Author Message
Gymmic10
Walk-On
Walk-On
Avatar

Joined: 6/10/05
Location: United States
Online Status: Offline
Posts: 0
bullet Topic: finishing touches on interior set
    Posted: 8/08/05 at 8:06pm

Hello!  We are in the final stages of building the interior set for our upcoming play.  Do you guys have any finishing touches that you always do before you open a show?  any necessaries from you set experts?   anyways...something specific.  what is a non-permanent way to cover that crack that you get inbetween flats on and interior set?  something that won't leave residue on the edges of our flats?  any other hints on sets will be greatly appreciated! thanks a lot!!!

IP IP Logged
Topper
Celebrity
Celebrity
Avatar

Joined: 1/27/05
Location: United States
Online Status: Offline
Posts: 543
bullet Posted: 8/09/05 at 1:06am
ALWAYS double-check points of stress -- doorknobs,
handles, hinges, stair-rails, bannisters, etc and
make certain these are SECURE. These things take
the most abuse night after night and will cause the
most danger or embarrassment should they fail.

Likewise, do a thorough sweep of the floor for any
loose nails, screws or errant hardware and debris.

As for concealing the void between flats:

FROM BEHIND SET: If the framing is made of thick
enough material, drill a hole in the framing of
adjoining flats and tighten these securely with a
sturdy carriage bolt, washers and wing nuts.
Alternate directions of the bolts and washers (one
from flat "A" to flat "B", the next from flat "B" to flat "A",
etc.) -- use as many as necessary to get the gap tight
and secure.

If the framing is not thick enough to accept a bolt,
then nail or screw 2x4 blocks at regular intervals
along the edges and drill through them instead.

IN FRONT: cover the void with that lovely 3M product
-- blue painter's tape. For added security you can
staple it to the flat's framing. Use the 2" width and
paint over it exactly as you did your flats. When
removed it leaves no residue.

Another solution is to add moulding to your set
design. Rather than attempt to camoflage the voids
between flats, a fluted moulding or raised panel
covers them in a decorative manner. Either paint
them the same color as your flat, or a complimentary
color to your design scheme. This works very well,
especially on Victorian interiors or sets requiring
older architecture.

You don't even need to nail the moulding on, but
merely lace a strong wire or cord through tiny holes
drilled in the moulding and secure it behind the flat
with cleats or bent-over nails.

"None of us really grow up. All we ever do is learn how to behave in public." -- Keith Johnstone
IP IP Logged
dboris
Celebrity
Celebrity


Joined: 2/10/04
Online Status: Offline
Posts: 124
bullet Posted: 8/09/05 at 12:58pm

A few other items to check...

Be sure to carefully check all your sight lines, they can be a real nightmare on interior sets that have a lot of doors and windows. For example when someone opens a door on the set, check from all angles in the house that you can't see backstage.

Check that flats that hold doors are well braced. Nothing I hate more then when someone closes a door and the whole wall shakes!

Try to make it look "real". Think about the details that you see in a real room, and add them to your set, these little details can make a big difference. For example if it's an apartment, is there an appartment number on the outside of the door (assuming it can be seen when opened).

Dan

IP IP Logged
Aimee
Celebrity
Celebrity
Avatar

Joined: 8/31/04
Location: United States
Online Status: Offline
Posts: 156
bullet Posted: 8/10/05 at 11:45am

When I am "building a room" to cover the seam between two flats I just use another strip of muslin  (4-6 inches wide) glued on,then painted the color of the flats. When you are done it will rip right off with out tearing the muslin underneath.  You can use masking tape too, but sometimes you can tell it is there.

I try to do some type of border around the top as well. Wallpaper or a wood trim work very nicley. It really "frames" the room up nicely. This only works well if you have a set you are not moving. I have used it on a set we "opened up" and it still worked well enough. It just was not a seamless as I would have liked.

Then I step back and look at it from the house and ask myself "what is missing?"  Sometimes it is just hanging a photo on the wall, or adding a vase of flowers to a table.

Best of Luck, hope this helps.

Aimee

Aimee
IP IP Logged
tblan
Lead
Lead
Avatar

Joined: 8/10/05
Location: United States
Online Status: Offline
Posts: 36
bullet Posted: 8/10/05 at 9:53pm

It may seem obvious but I can't count the number of productions that forgot about backing flats.  You should have them behind every window and door that the audience can see. 

Did you include light switches, even if the lights don't get turned on and off?

IP IP Logged
travsbluecar
Walk-On
Walk-On
Avatar

Joined: 8/11/05
Location: United States
Online Status: Offline
Posts: 0
bullet Posted: 8/11/05 at 5:04pm

What I always do is get some brown spraypaint and make "wear marks".  What I mean is add a light touch of paint around light swiches, door handles and any where I think my set would have been touched on a repeated basis.  I also go around the paintings hanging on the wall (be careful if these are borrowed, you may want to take them off the wall before you paint).

I then step back and look at the set as a whole and see if anything is missing - like swich plates, personal items that the people in story would want or need.  I also consult with the actors to check their interp of their character.  Details - Details - Details. 

IP IP Logged
Gymmic10
Walk-On
Walk-On
Avatar

Joined: 6/10/05
Location: United States
Online Status: Offline
Posts: 0
bullet Posted: 8/15/05 at 6:26pm

Thank you guys for all of your help!  Those ideas are great.  They will help out a lot.  Any other ideas wouldn't hurt, so if you have them...send them on!!!  Thanks again!!!

IP IP Logged
Thespian_4_ever
Lead
Lead
Avatar

Joined: 9/16/05
Location: United States
Online Status: Offline
Posts: 43
bullet Posted: 3/17/06 at 3:41pm

Always check doors and doorknobs...

A play I saw once have the door fall of when the actors went through it...

IP IP Logged
Post Reply Post New Topic
Printable version Printable version

Forum Jump
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Bulletin Board Software by Web Wiz Forums version 8.05
Copyright ©2001-2006 Web Wiz Guide
buy generic cialis are in line cialis canada outcome for yourself viagra sales cost saving benefit viagra uk convert your buy phentermine online pay phentermine cod payment Lenders Everything xanax online your existing xanax overnight absolute must free incest stories online The value gay incest advance The key free dog sex pics cash flow dog sex the reduced noise free gay college guys of the period gay guys